A failing tank or fitting can release a full tank of water in one go. The Hanahan crew pumps the spread, checks walls and flooring around the unit and dries what the water reached.
(888) 532-8921Tank leaking? Call for cleanup
Shut the cold water valve above the tank so the flow into it stops.
Switch off the breaker or the gas control, and stay out of standing water near the unit.
Run a hot faucet to relieve pressure and let the tank drain away from the wet area.
Capture the unit, the water and any wet walls or belongings.
Water Heater Leak Cleanup: the trade facts
A water heater holds a large tank of water, and when a seam, a valve or a fitting gives way, most of it can reach the floor in one go. Slow drips from a fitting are quieter and can soak a wall base for weeks. Either way, the cleanup starts with shutting off the supply and the power.
A garage or bare floor leak costs $900 to $2,000. A closet and nearby rooms run $2,000 to $4,000, and an attic unit or wide spread runs $3,800 to $6,000. Carpet, wall bases and ceilings decide the tier.
$900 to $2,000
$2,000 to $4,000
$3,800 to $6,000
Ranges are typical figures, not a quote. The category of water, the square footage, the material class and how fast drying started move the number most. The water damage cost calculator gives a closer range.
The tech who does the walkthrough finds the source and maps the moisture before equipment goes down, and the drying team keeps it running until the readings say dry.
Pumps and extractors clear the water from the floor and low corners.
Meters and a camera test baseboards, wall bottoms and nearby rooms.
Wet pad, baseboard or board that cannot dry is cut out.
Air movers and a dehumidifier run until readings return to normal.
The supply valve on the cold side shuts the flow, and the power or gas for the unit is switched off before anyone goes near the water. Electric units in a wet closet are an electrical hazard, so the breaker comes first. A plumber replaces the heater, while the restoration crew handles the water.
Supply water from a tank is clean, so most materials can be saved if the cleanup is quick. Pad and baseboard in a closet often come out, while hardwood and drywall can often be dried in place with mats, air movers and a dehumidifier. Delay is what turns a small job into a bigger one.
A pipe failure elsewhere in the house falls under burst pipe water damage, and spreading water may need emergency water extraction. The Hanahan hub lists the others.
Water heater leak calls cover ZIP 29410, including Tanner Plantation, Tanner Commons, Charleston Oaks, Mossy Creek and Edgewood Trace, plus South Cove, Sweetgrass and Amber Glen.
The same service nearby: water heater leak cleanup in Goose Creek, North Charleston, Charleston.
Yes, supply water from the tank is clean. Rusty tint or sediment may stain surfaces, though it does not change how the structure is dried.
Sometimes. Clean water caught fast can be extracted from carpet, while the pad under it is often replaced.
A plumber installs the new unit. The restoration crew handles the water, the wet materials and the drying around it.
Concrete soaks up water slowly and releases it slowly, so the floor and the bottoms of the walls get meter checks.
Sudden failures are often covered, while long drips may not be. Photos of the unit and the water help the adjuster.
Water wicks into the bottom of drywall and insulation. The crew checks it with a meter and opens it only if it stays wet.
Water heater leaking? Dispatch runs 24/7.
A released tank soaks carpet, pad and wall bases fast. The crew extracts the water and dries what it reached.